Powerful cleansing
power – Highly concentrated foam
cleaner formulated to remove mold and mildew
stain as well as tough soap scum and hard
water stains in the bathroom. This product
can also be applied on the exterior wall of
building made of concrete or brick.
(1) Shower
tile, Wall, Joint wall, Shower curtain and
Bathtub (made of plastic or stainless) in
the bathroom. (2)
Exterior wall of building made of concrete
or brick.
1.
Turn the opening of the
nozzle left (Do not turn the
nozzle towards your face).
2.
Spray this product on the
mold stain and leave for a
few minutes. Then wash away
with water
(* Use sponge to clean when
this product is applied
above eye level, followed by
wiping off with wet cloth).
3.
After usage, turn the
opening of the nozzle right
and keep in a cool dark
place. Wash hands well after
usage.
Spray over 1 ㎡ with 15 times
push (about 13g)
MOLD
REMOVAL TEST
Shower Tile, Joint Wall
at Bathroom
Exterior Wall of Building
Mildew
MOLD REMOVAL Q & A
Q1
How to prevent mold at the bathroom?
A1
a) Ventilate
the bathroom frequently. Mold is easy to
breed at places where temperature 20-30°C
and humidity 75-100%.Therefore it is
important to ventilate the bathroom well to
reduce temperature and humidity. After
taking a bath, it is recommended to wash the
bathtub by water and ventilate the bathroom
for around 1 hour.
b) Clean immediately after mold is found. If
mold is remained in bathroom, it will attach
to the inner part of joint wall and become
very difficult to cleanup. Clean at an early
stage is very important.
Q2
How to effectively use the Asahipen Mold
Removal Super Spray?
A2
If the mold
removal spray is used on damp surface, it
may be diluted and the sprayed-out mousse
might be slipped from the surface. Thus it
should be applied on dry surface.
For stubborn mold stain, spray the product
on the mold directly, put a tissue paper on
it, spray again on tissue paper and leave it
for 10-15minutes. After that peel off the
tissue paper and wash well by water.
Q3
How to paint the wall in the bathroom where
mold is bred?
A3
Mold is still
alive if paint is applied on the wall where
mold is bred and the mold may appear on the
surface of paint subsequently. Hence, mold
shall first be removed by Asahipen Mold
Removal Super Spray before applying paint.
